Pavers Split Face Granite - Sandstone [500 x 500 x 45]

Concrete pavers - These pavers have the appearance of granite that has been mechanically split and offer a low glare finish. 

Call for pallet rate - 48 pavers per pallet.

SIMPLE TIPS ON INSTALLATION

Pavers can be laid by any competent do-it yourself enthusiast. For large projects the best results are obtained by employing competent paving contractors. If you do this yourself take note of the following;

• Choose your site carefully taking note of drains, trees and electrical cables
• Check heights to make sure that the surface is below floor level and slopes away from the house.
• If the ground is firm and well compacted excavate to a depth of approximately 75mm. If the site is soft or not well compacted, excavate a further 50mm and add 50mm of top-course which should be well compacted
• Spread a 50mm layer of loose bedding sand over the base. Screed and level.
• Set up string lines to guide you for height and line.
• Lay pavers carefully following your chosen laying pattern.
• N.B. - never use a compactor on the surface of the tiles
• Leave a gap of 8-10mm between pavers to accommodate minor size variations and to avoid chipping.
• If pavers need to be cut, hire a suitable masonry saw and remember to wear safety equipment.
• When all the pavers have been laid, hose them off and allow them to dry thoroughly. Spread pave-lock grouting, mortar pointing or similar to fill the gaps.
• Use a sand and cement mix to create a 45degree edge to give the pavers a border where needed and to hold the pavers in place.

TYPE:Landscape Structure